TAKAAB SAR - Gate Controlled Slew Limiter / Slide-Portamento / AR Envelope
The Takaab S.A.R (Slide, Attack, Release) is a voltage lag generator designed primarily to function as either a portamento/slide circuit or an AR envelope generator.
With both the push switches out (ON) a voltage applied to the main input will be outputted with any rises or falls in voltage being slowed down dependant on where the A (attack/rise) and R (release/fall) knobs are set to. Therefore, inputting a 1v/oct control voltage will result in a portamento effect, whilst a smooth rising and falling envelope can be generated by inputting a gate.
With the switches pushed in (AUTO) the lag effect will be normally off and will be switched on whenever a gate signal is present at one or both of the adjacent jack inputs. - If a jack is only inserted into one of these inputs then any gate will affect both A and R. Plugging separate jacks into both the A and R inputs will give independent gate switching of each of these parameters.
The ‘Curve’ knob gives control over the curve of the lag, ranging from nearly linear to a logarithmic curve. It also somewhat effects the overall length, with the lag becoming a little longer the more curved it is.
The range switch changes the range of the lag time: The centre position being the shortest and is most useful for slides or portamentos. The top position is the middle setting while the lower position is the longest range – most useful for envelopes. At this range you may hear some lag even with A and R at their lowest settings if using the unit as a portamento.
Size: 3cm (6HP) x 128.5cm x 6.1cm.
Module depth: 42mm.
1 signal input jack, one output jack, two gate input jacks to switch on A and R parameters.
Package contents: 1x module, 1x 10 pin power cable, 2x 3M screws, Jumper.